6-8
The CE6000-120AP analyzes the cutting data, and controls the angle of the cutter blade tip if the change in the
angles of the corner s large.
Angle control is applied if there is larger angle change than the angle specified as reference angle.
The tme to cut s shortened by settng large value for the reference angle, snce t wll only apply blade control
when there are angles wth large angle change, hence reducng the tme to make the blade control.
But, f t s set too large, there wll be not enough angle control of the blade, and the cut result may dffer from what
was expected. Set the reference angle n good balance.
Supplement
Ths settng s mantaned even f the power s turned off.
Operation
Supplement
Perform the settngs n Normal menu.
1
Press the [PAUSE/MENU] key.
MENU screen s dsplayed.
2
Press the [1] key (TOOL).
TOOLS SETTING screen (1/3) s dsplayed.
3
Press the POSITION ( ) key.
TOOL SETTING screen (2/3) s dsplayed.
4
Press the [1] key (OFFSET ANGLE).
OFFSET ANGLE screen s dsplayed.
Supplement
Settng range s from 0 to 60.
5
Press the POSITION (
) key and ncrease or decrease the
settng value.
6.3
Setting the Offset Angle
