2-38
Lnes can be cut wth perforated lnes so the cut parts wll not fall off. There are 8 dfferent perforaton patterns
of perforated lnes set as 0 to 7, and the rato of cut and uncut part dffers n each. (Cut length decreases cuttng
perforaton length, up length decreases the perforaton connecton length or the connecton cut force.)
The cut part becomes longer wth a larger value, and becomes easer to separate the cut parts wth a smaller up
value.
In addton to above 8 patterns, there are "OFF", whch cuts by the sold lne wthout perforaton patter, "NONE",
whch controls the perforaton patter wth the command, and "USER", where user can specfy a unque pattern.
The processng n the part s not cut wth perforaton patter s adjusted n "UP MODE".
The perforaton patter can be set for each condton number.
Supplement
Use the holder (forward).
Flange
Bracket to hold tool
Ths cutter holder s
not set backward.
Cutter holder
(Forward)
Flange
Damaged markng mats can be replaced at the owner's expense.
When controllng the perforated pattern wth FORCE settng command, set to "NONE".
Guideline to perforation pattern
Thickness of material
Pattern number
Cutting length (L)
Up length (L)
Approx. 130 g/m
2
3
30.00 mm
1.00 mm
Approx. 80 g/m
2
5
30.00 mm
1.40 mm
Approx. 65 g/m
2
1
15.00 mm
1.40 mm
* The materals of 60g/m
2
or less are not sutable for cut wth perforaton pattern. We recommended that they
are used for a pen plottng.
Operation
Supplement
Condition No.1 is pen specific. When setting
up tool condtons for the cutter plunger, please
choose from Condton No.2 to Condton
No.8 under "Selectng the Tool Condton". For
more nformaton, see "2.10 Selectng Tool
Condton"
P.2-29
.
1
Press the [COND/TEST] key.
CONDITION settng screen (1/3) s dsplayed.
2.11
Setting Cut Line Pattern
