GRAPHTEC CE6000-120AP, User Manual

Page: 159 / 227

8-3
Connecting with RS-232C
The RS-232C settngs can remember up to 8 dfferent settngs that can be swtched f necessary.
Call up the settng to be used accordng to "Swtchng the user selecton settng" P.8-4 , and then change and
save the RS-232C settngs accordng to "Changng and savng the RS-232C nterface settng" P.8-5 ".
Setting user selection
Call up the user selection settings (CAD). "Command", "Origin point", "Step size", "Separator", "Timeout", "Page
length", and "Transfer condtons for RS-232C" have been set.
List of user selection settings
User selection settings 1 2 3 4 5 6 7 8
Command HP-GL HP-GL GP-GL HP-GL HP-GL HP-GL HP-GL HP-GL
Step size 0.025 0.025 0.025 0.025 0.025 0.025 0.025 0.025
Orgn pont LOWER
LEFT
CENTER LOWER
LEFT
LOWER
LEFT
LOWER
LEFT
CENTER CENTER CENTER
Separator PG NR J0 SP PG SP None None
Tme out 0 0 120 120 1 10 0 0
Page length (mm) 1500 3000 1500 5000 3000 1500 5000 5000
Transfer condtons 9600N81X 9600N81X 9600N81X 9600N81X 9600N81X 19200N81X 9600N81X 9600N81X
Step pass – – – – – 0 – –
Tool up speed – – – – – 60 cm/s – –
Cross cut – – – – – ON – –
Cut lne pattern – – – – – OFF – –
Space rear – – – – – 12 mm – –
–: The current value s set.
User preference 6 s determned as per the followng cutter pen condtons (all settngs other than those lsted
revert to default).
The settngs other than the table are set to default value.
Condition No. Speed Acceleration Force Pen type
(Cutter blade)
Compensation value
(Offset)
1 60 1 17 Pen –
2 30 1 14 09U 0
3 30 1 14 09U 0
4 30 1 14 09U 0
5 30 1 14 09U 0
6 30 1 14 09U 0
7 30 1 14 09U 0
8 60 1 14 09U 0