GEFRAN-SIEI ARTDrive Vector V2 400Vac Series, Instruction Manual

Page: 128 / 387

Index
MENU MENU
MENU MENU
MENU
[Unit] Access Default Min/Max Format Reg.Mode Level Ipa
Parameter Name
Description
Chapter 6 Parameter • 128 ARTDrive V2 series - Instruction Manual
C00.02 Term Stop src N/A RWS Ipa4000 PList 16 PIN V-F-S-B Full 9211
Ipa 4000 - NULL = Default
It allows to select the signal to generate the terminal strip Stop command.
ª ª ª ª ª
Pick List 16
N
OTE
!
Signal active only when “
C00.20 - Commands select
= [1] TerminalEdge
The
Start
and
Stop
commands can be controlled, as an alternative, via:
•
a single terminal
in this case (+24V) 1 refers to the Start and (open) 0 to the Stop
+ 2 4V STA R T= C lo s e d, ST O P=op e n
Figure C00.02-1: Start/Stop controlled via single terminal
•
two terminals connected with buttons
in this case the change of state is caused by the positive edge (0 to1) on the
terminal.
STA R T
ST O P
+ 2 4V
STA R T
ST O P
+ 2 4V
Figure C00.02-2: Start/Stop controlled via two terminals with buttons
C00.03 Term Local src N/A RWS Ipa4000 Plist 16 PIN V-F-S-B Easy 9212
Ipa 4000 - NULL = Default
It allows to select the signal to obtain the local commands by keypad.
ª ª ª ª ª
Pick List 16
The following picture shows the selection logic for the source of
Start
and
Stop
commands:
[1] Local
C ommand s ou r c e
s e l e cto r C 00 - 2 0
[ 2 ] Digital L e v e l
[1] T er minal Edg e
C 00 -43
C 00 - 0 3 = Digital input
To d r iv e command logic
[ 0 ] T er minal L e v e l
[ 0 ] Re mot e
[3] Digital Edg e
[4] I O K e y s
Figure C00.03: Command selection
When the selector (dedicated digital input) is 0 (Remote),
Start
and
Stop
commands
come from the source specified by parameter C00.20.
When the selector (dedicated digital input) is 1 (Local),
Start
and
Stop
commands come
from the keypad, regardless what is set into parameter C00.20.