GE Ultrasonic USM Go, Operator'S Manual

Page: 72 / 190

Chapter 2. Instrument Setup
54 USM Go Operator’s Manual
2.6 Calibrating the Instrument
To calibrate the USM Go, follow the instructions in this section.
2.6.1 Pre-Calibration Check List
To improve the accuracy and quality of your calibration, be sure that the following steps have been taken before beginning the calibration:
•
Install the probe
•
Adjust the
DUAL (RECEIVER)
setting to match probe
•
Set the material type
•
Set the
DISPLAY DELAY
to 0 (recommended)
•
Set the
PRF
to
AUTO LOW
•
Set
TCG
to
OFF
•
Set
REJECT
to 0 (recommended).