GE Ultrasonic USM Go, Operator'S Manual

Page: 53 / 190

Chapter 2. Instrument Setup
USM Go Operator’s Manual 35
2.3.3 Defining Function Toggle Actions
The user can specify a desired action to occur when either end of the Function Toggle ( ) is pressed or pressed-and-held. The
user-specified function action is ignored, however, whenever a parameter is selected and its value is being edited.
1. In the SETUP menu, activate the CONFIG2 submenu using the joystick ( ). Several functions are displayed on the screen.
2. Use the joystick ( ) to select either the function titled
FUNCTION1
, for the end of the toggle closer to the display screen, or the
function titled FUNCTION2 , for the end of the toggle further from the display screen. Then, press the center of the joystick ( ) to
activate the function.
Note:
There are two values for each function. The upper parameter determines the action taken when then corresponding toggle end is
momentarily pressed. The lower parameter defines the action taken when the toggle end is pressed and held.
3. To change the upper parameter, move the joystick left or right ( ).