Chapter 2. Instrument Setup
38
USM Go Operator’s Manual
2.4.2 Configuring the Instrument
Three instrument settings are directly dependent on the type of probe installed. These settings must be adjusted any time a probe of a
different type is installed, by following the instructions in the following sections.
2.4.2a Selecting the Probe Type
(RECEIVER-DUAL)
1.
In the
ACQUIRE
menu, activate the
RECEIVER
submenu using the joystick (
).
2.
Use the joystick (
) to select the function titled
DUAL
.
3.
To change the probe type, move the joystick (
) or press the function toggle. Each available probe type is represented by an icon in
the
Icon Bar
, near the upper left corner of the display, whenever that probe type is highlighted. The following options are available:
•
ON
-
Use
f
or
dual-element
probes. If this option is selected, the
Dual
icon (see
Figure 6 on page 17
) is displayed.
•
OFF
-
Use
f
or
single-element
probes. If this option is selected, the
Single
icon (see
Figure 6 on page 17
) is displayed.
4.
After completing your selection, move the joystick up or down (
) to navigate away from this function.
Summary of Contents for Ultrasonic USM Go
