GE Medical Systems marquette Dash 2000, Service Manual, Page: 141 / 202

CONFIGURATION: Setup For Use
Revision A DASH 2000 Patient Monitor 6-27
2000 412-001
3. The SET BED NUMBER pop-up window appears on the monitor
display as shown below.
The SET BED NUMBER pop-up window displays either the current
BED NUMBER or is completely blank. The software supports up to
five alphanumeric characters to be used in the BED NUMBER field.
NOTES
It is important that the correct BED NUMBER be
entered with regard to other monitors within the same
care unit. If a mistake is made in programming the BED
NUMBER field, the worse-case being a duplicate BED
NUMBER on two different monitors within the same
care unit, the monitor cannot communicate properly on
the network and presents problems when the monitor is
setup or configured for display at central stations.
4. Two sets of arrow icons appear in the BED NUMBER pop-up window.
Rotate the Trim Knob to highlight one of the sets of arrows and press
it to enable each function:
¥ The horizontal (left/right) arrows, when highlighted and enabled,
allow the user to select a specific character for change by rotating
the Trim Knob control. A press and release of the Trim Knob
while a specific character is highlighted, enables that specified
character for change.
¥ The vertical (up/down) arrows, when highlighted, allow the user
to scroll through all of the alphanumerics available for each
character in the BED NUMBER. Rotating the Trim Knob control
at this point allows the user to select a specific alphanumeric to
be entered into the specified character position within this field.
To enter the chosen character into memory, press and release the
Trim Knob control one more time.
5. Repeat step 4 for each character to be entered as part of the BED
NUMBER. Up to five characters may be setup or configured. The
manufacturer recommends that user-defined BED NUMBER
consisting of less than five characters, be left-justified and leave
unused character positions (those to the right of the user-defined bed
number) blank.
6. When finished making each character entry, use the Trim Knob
control to select the SET BED NUMBER menu option item. Press the
Trim Knob control. This programs the newly entered BED NUMBER
into the monitor memory and closes the pop-up window.
MAIN
MENU
PREV.
MENU
SET
UNIT
NAME
SET
BED
NUMBER