GE Medical Systems marquette Dash 2000, Service Manual, Page: 129 / 202

CONFIGURATION: Load Software Over The Network
Revision A DASH 2000 Patient Monitor 6-15
2000 412-001
3. Follow the instructions on the screen to exchange diskettes in the
hard drive as each one is loaded on the Clinical Information Center
hard drive.
4. When loading of diskette 3 is complete, the Clinical Information
Center displays the message:
INSTALL COMPLETE.
5. Click on the ÒXÓ in the upper right hand corner of each screen to close
out the download screen and the main screen.
Download Files to
the Monitor
The following steps describe how to download files from the network to
the monitor.
NOTE
Verify the monitor is on the network by selecting LIST
NETWORK from the SERVICE MONITOR menu of the
central station or CURRENT TELEMETRY LISTINGS
from the SERVICE menu of the CIC system
1. At the monitor, start the BOOT LOADER program by following these
steps:
¥ Hold down the NBP GO/STOP and FUNCTION keys,
¥ Press and release the Trim Knob control, and
¥ Hold the NBP GO/STOP and FUNCTION keys until the BOOT
LOADER menu appears on the monitor display.
2. Use the Trim Knob to select the following at the FILE SERVER
SELECTION menu:
¥ In the menu list, identify and scroll to the central station which
has the update files stored on it (this should have been noted or
written down earlier in the procedure). This central station acts
as a file server to download files to the monitor over the network.
¥ Select the number corresponding to the central station that
contains the update files.
3. Use the Trim Knob to scroll to and select the number from the
DIRECTORY SELECTION menu corresponding to:
/update.net/dash2000/<version>
4. Compare the revision of the file to be updated with the software
revision of the corresponding area of the monitor. Perform the
following steps only if a file existing in the monitor is older than the
update files just copied onto the central station hard drive.