GE HEALTHCARE MAC 2000, Operator'S Manual

Page: 46 / 226

Setting Up the Equipment
Use the following instructions to connect the system to an AC power outlet.
Item Description
1
Female end of the device’s power cord connected to the back of the device.
2
Male end of the device’s power cord connected to an AC outlet.
1. Connect the female end of the device’s power cord (1) to the AC power connector
on the back of the device.
2. Plug the male end of the device’s power cord (2) into an AC outlet.
NOTE:
It is recommended that you plug the device into an uninterruptible power
supply (UPS) or a surge suppressor.
3. Check the Power LED to make sure the device is receiving power form the AC
outlet.
Connecting the Patient Cable
This system supports a variety of patient cables.
WARNING:
HIGH-FREQUENCY BURNS — Use of cables not supplied with this equipment can
lead to serious injury.
Use only the acquisition cable that ships with this equipment.
CAUTION:
INACCURACIES IN ECG Improper connection can cause inaccuracies in the ECG.
Trace each individual leadwire from its acquisition cable label to the colored
connector and then to the proper electrode to ensure that it is matched to the
correct label location.
46 MAC™ 2000 2053535-002K