F - 160 Operation and Maintenance Manual
© GBC Pro - Tech August 1999
Page 6 - 79
Applications
Materials needed
• Prints ( Decals )
• Substrates
• Utility knife
• Leader board ( substrate width x 6” )
Set up
a) Replace the front infeed table.
W A R N I N G
Keep hands and fingers clear of the
laminator roller nip when changing GAP.
Y o u c a n b e C R U S H E D o r B U R N E D !
b) Position the leader board between the pull
rollers.
W A R N I N G
Keep hands and fingers clear of the pull
roller nip when changing the gap.
Y o u c a n b e C R U S H E D !
c) While observing the leader board at eye level,
lower the upper pull roller by turning the pull roll
crank handle clockwise until contact with the
leader board has been made.
CAUTION
Sharp edges on a substrate should be filed
smooth and GAP manually adjusted.
Sharp edges can CUT the rollers!
If the thickness of the substrate is not
known, follow the procedure to manually
set the nip in Section 5.5.2 Manually nip
adjustment.
INFORMATION
CAUTION
Excess pressure can damage the laminating
rollers. Always use the minimum roll
pressure necessary to complete the task.
Excessive pressure will cause the
substrate to bow or flatten.
INFORMATION
