© GBC Pro - Tech August 1999
Page 6 - 48
F - 160 Operation and Maintenance Manual
Applications
INFORMATION
Steps " j" and " k " will be performed
simultaneously.
j) Push the leading edge of the substrate with the
decal up to the nip of the main rollers.
W A R N I N G
When operating the laminator using the
variable speed footswitch, keep hands and
fingers away from the nip of the rollers.
Y o u m a y b e C R U S H E D o r B U R N E D !
k) Using the variable speed footswitch, slowly
work the substrate into the nip of the rollers
and stop just before the end of the tacked
down section of the image enters the nip.
Use a slow speed. If the tack point enters
the rollers nip, you will not be able to
pull the release liner.
INFORMATION
Speed is controlled through the variable
speed footswitch when the safety shield
is in the raised position.
CAUTION
- If the tack point enters the rollers nip perform
the following steps.
1) Press STOP
2) Press REV
t
t
t
t
t
3) Press the variable speed footswitch
to back the tack point out of the
rollers nip.
4) Press STOP
5) Press FWD
s
s
s
s
s
6) Continue from step i).
l) Drape the loose part of the decal over the
upper main roller. Refer to Figure 6.5.12
Figure 6.512 Draping the decal
Upper
Main
Roll
Decal
Release liner
Substrate