F - 160 Operation and Maintenance Manual
© GBC Pro - Tech August 1999
Page 6 - 15
Applications
Use a slow speed. If the tack point enters
the rollers nip, you will not be able to
pull the release liner.
INFORMATION
- If the tack point enters the rollers nip perform
the following steps then continue with this
procedure.
1) Press STOP
2) Press REV
t
t
t
t
t
3) Press on the variable speed
footswitch to back the tack point
out of the rollers nip.
4) Press STOP
5) Press FWD
s
s
s
s
s
6) Continue from step i).
Speed is controlled through the variable
speed footswitch when the safety shield
is in the raised position.
CAUTION
j) Drape the loose part of the image over the
upper main roller. Refer to Figure 6.2.7
Figure 6.2.7 Draping the image
Upper
Main
Roll
Image
Release liner
Pre-coated board
k) Make sure the image is conformed to the upper
main roller. Refer to Figure 6.2.8
If the image is not conformed to the roller,
you may experience difficulties with
this application.
INFORMATION
Figure 6.2.8 Conformed print
Upper
Main
Roll
Conformed
W A R N I N G
When operating the laminator using the
variable speed footswitch, keep hands and
fingers away from the nip of the rollers.
Y o u m a y b e C R U S H E D o r B U R N E D !
