© GBC Pro - Tech August 1999
Page 6 - 34
F - 160 Operation and Maintenance Manual
Applications
h) Remove the web from the front of the laminator
and the rolls of material from the upper and
lower unwind shafts.
This will prevent any exposed adhesive from
contacting the rollers.
INFORMATION
i) Clean the rollers as described in the
maintenance section. ( Section 8.2 Cleaning
the rollers )
j) Replace the front infeed table.
k) Lower the front and rear safety shields and
press SHUTDOWN if finished with the
laminator.
S E L
S A V
S H U T D O W N
0
J O B
End of application
6.5 Decal and mount
This application may be performed from the
front of the laminator using the main rollers or from the
rear of the laminator using the pull rollers in the event
the main rollers are heated. This application is explained
in detail using the main rollers from the front of the
laminator.
This is a two pass mount and laminate process.
Two pass meaning that the print will pass through the
laminator twice. The first pass ( Decal ) will apply a
mount adhesive to the back of the print while applying a
laminate to the front of the print. Use Chart 5 and
Diagram 5 for assistance. The second pass ( Mount )
will adhere the decal to a substrate. Use Chart 6 and
Diagram 6 for assistance.
This application can be performed in various
methods. The process described in this manual is the
most common method.
W A R N I N G
Do not wear ties, loose fitting clothing or
dangling jewelry while operating or
servicing the laminator. These items can get
caught in the nip and choke you or you can
be crushed or burned.
Pass 1: Decal
Use Chart 5 and Diagram 5 for assistance.
