Garmin G1000 NXi Cockpit Reference Guide for the da62
190-02622-00 Rev. A
151
annunciations & alerts
Flight
Instruments
EIS
Nav/Com/
XPDR/Audio
Flight
Management
Hazar
d
Avoidance
AFCS
Additional
Featur
es
Annun/Alerts
Appendix
Index
Flight
Instruments
EIS
Nav/Com/
XP
d
R/
a
udio
Flight
Management
Hazar
d
avoidance
a
FCS
a
dditional
Featur
es
a
bnormal
o
per
ation
a
nnun/
a
lerts
a
ppendix
Index
System Message
Comments
CHECK CRS
– Database course
for LOC2 / [LOC ID] is [CRS]°.
Selected course for LOC2 differs from published localizer course by
more than 10 degrees.
CNFG ModULE
– PFD1
configuration module is
inoperative.
The PFD1 configuration module backup memory has failed. The
system should be serviced.
CoM #[1, 2] INoP - CaL
–
Check COM Calibration.
COM 1 and/or COM 2 calibration version error. Check COM
calibration.
CoM #[1, 2] INoP - CRNT
–
Check COM Current.
COM 1 and/or COM 2 current is low. Check COM current.
CoM #[1, 2] INoP - INTRL
–
COM Internal fault.
COM 1 and/or COM 2 has an internal fault.
CoM #[1, 2] INoP - SyNTH
–
COM Synthesizer Lock Fault.
The COM 1 and/or COM 2 has a synthesizer lock fault.
CoM #[1, 2] INoP - VoLT
–
Check COM Voltage.
COM 1 and/or COM 2 has low voltage.
CoM1 PTT
– COM1 push-to-talk
key is stuck.
The COM1 external push-to-talk switch is stuck in the enable
(or “pressed”) position. Press the PTT Switch again to cycle its
operation.
If the problem persists, the system should be serviced.
CoM2 PTT
– COM2 push-to-talk
key is stuck.
The COM2 external push-to-talk switch is stuck in the enable
(or “pressed”) position. Press the PTT Switch again to cycle its
operation.
If the problem persists, the system should be serviced.
daTa LoST
– Pilot stored data
was lost. Recheck settings.
The pilot profile data was lost. System reverts to default pilot
profile and settings. The pilot may reconfigure the MFD & PFD with
preferred settings, if desired.
daTaBaSE CHaNGE
– Verify
user modified procedures.
This occurs when a stored flight plan contains procedures that have
been manually edited. This alert is issued only after an navigation
database update. Verify that the user-modified procedures in stored
flight plans are correct and up to date.
daTaBaSE CHaNGE
– Verify
stored airways.
This occurs when a stored flight plan contains an airway that is no
longer consistent with the navigation database. This alert is issued
only after an navigation database update. Verify use of airways in
stored flight plans and reload airways as needed.
daTaBaSES EXPIREd
– Restart
avionics to activate standby
databases.
The databases in the system have expired. Restart the system to
move the standby databases to active status.
Summary of Contents for G1000 NXi
Page 1: ...Cockpit Reference Guide Diamond DA62 System Software Version 2056 10 or later...
Page 2: ......
Page 4: ......
Page 219: ......
