Garmin G1000 NXi, Cockpit Reference Manual

Page: 155 / 220

Garmin G1000 NXi Cockpit Reference Guide for the da62 190-02622-00 Rev. A 131
additional Features
Flight
Instruments
EIS
Nav/Com/
XPDR/Audio
Flight
Management
Hazar
d
Avoidance
AFCS
Additional
Featur
es
Annun/Alerts
Appendix
Index
Flight
Instruments
EIS
Nav/Com/
XP
d
R/
a
udio
Flight
Management
Hazar
d
avoidance
a
FCS
a
dditional
Featur
es
a
bnormal
o
per
ation
a
nnun/
a
lerts
a
ppendix
Index
4)
Press the SaT - or SaT + , to adjust display saturation in five percent increments from 0 to
100%.
5) If desired, return the display to the default settings by pressing the Reset Softkey.
6) Press the
Back
Softkey to return to the previous softkey level.
ELECTRoNIC STaBILITy aNd PRoTECTIoN (oPTIoNaL)
NoTE:
ESP is designed to discourage exceeding the normal flight envelope. It is
not designed or capable of performing the necessary recovery procedures due to
encounters with adverse flight conditions and environments.
NoTE: Refer to the current version of the pertinent flight manual to determine approval
of ESP functionality.
The pilot can interrupt ESP by pressing and holding either the Control Wheel Steering
(
CWS
) Switch or Autopilot Disconnect (
AP DISC
) Switch. Upon releasing the
CWS
or
AP
DISC
Switch, ESP force will again be applied, provided aircraft attitude and/or airspeed are
within their respective engagement limits. ESP can also be overridden by overpowering the
servo’s mechanical torque limit.
Enabling/disabling ESP:
1)
Turn the large
FMS
Knob to select the ‘Aux’ Page Group.
2)
Turn the small
FMS Knob
to select the ‘Aux - System Setup’ Page.
3)
If necessary, press the
Setup 2
Softkey to display the ‘Aux - System Setup 2’ Page.
4)
Press the
FMS
Knob to activate the cursor.
5) Turn the large
FMS
Knob to place the cursor in the Stability & Protection field.
6) Turn the small
FMS Knob
to select ‘Enabled’ or ‘Disabled.’
7) Press the
FMS
Knob to remove the cursor.
ESP is automatically enabled on system initialization.
daTaBaSE CyCLE NUMBER aNd REVISIoNS
Viewing database information:
1)
Turn the large FMS Knob to select the ‘Aux’ Page Group.
2)
Turn the small FMS
Knob
to select the ‘Aux - System Status’ Page.
3) Touch the softkey corresponding to the display ( MFd1 or PFd1 ) for which the database
information will be viewed.
4) Press the FMS Knob to activate the flashing cursor in the ‘MFD1 Database’ or the ‘PFD1
Database’ Window.