Garmin G1000 NXi, Cockpit Reference Manual

Page: 117 / 220

Garmin G1000 NXi Cockpit Reference Guide for the da62 190-02622-00 Rev. A 93
Hazard avoidance
Flight
Instruments
EIS
Nav/Com/
XPDR/Audio
Flight
Management
Hazar
d
Avoidance
AFCS
Additional
Featur
es
Annun/Alerts
Appendix
Index
Flight
Instruments
EIS
Nav/Com/
XP
d
R/
a
udio
Flight
Management
Hazar
d
avoidance
a
FCS
a
dditional
Featur
es
a
bnormal
o
per
ation
a
nnun/
a
lerts
a
ppendix
Index
addITIoNaL WEaTHER RadaR dISPLayS
Enabling/disabling airborne Weather Radar overlay on the ‘Map - Navigation Map’
Page:
1)
Select the ‘Map- Navigation Map’ Page.
2)
Select the Map opt Softkey.
3)
Select the WX Radar Softkey.
or :
1) On the ‘Map - Navigation Map’ Page, press the
MENU
Key.
2)
With ‘Map Settings’ highlighted, press the ENT Key.
3) Turn the small FMS Knob to select the ‘Weather’ group, then press the ENT Key.
4) Turn the large FMS Knob to scroll through the product selections and highlight the
‘Weather Radar’ overlay selection (‘On’ or ‘Off’). Turn the small FMS knob to highlight
the desired selection.
5) To remove the menu, press the
FMS
Knob or
CLR
Key.
adjusting the bearing and antenna tilt angle on the 'Map - Navigation Map' Page:
1)
With the weather radar overlay enabled, push the Joystick twice. The bearing and tilt
legend is displayed in the lower-left corner of the map.
2) Move the
Joystick
up to adjust the antenna tilt angle downward, or move the
Joystick
up to adjust the antenna tilt angle upward.
3)
Move the Joystick left or right to adjust the bearing line in the desired direction. A
dashed bearing line is displayed during and momentarily after adjustment.
Controlling of weather radar information on the HSI Map:
1)
If necessary, enable the HSI Map on the PFD.
2)
On the PFD, press the Map/HSI Softkey.
3) Press the Wx Radar Softkey to enable/disable the airborne weather radar HSI Map
overlay.
4) Press the RdR opt Softkey.
5) To select a weather radar mode, press the
Mode
Softkey
a)
Press a softkey for the desired mode: Standby , Weather, or Ground .
b) When finished, press the Back Softkey.
6) Press the Gain- Softkey to decrease the gain setting or press the Gain+ Softkey to
increase the gain setting in increments of 0.5 with each press, or press and hold the
softkey for continuous adjustment. A gain setting of 0.0 is equivalent to the calibrated
gain setting.
7) Move the PFD Joystick up to adjust the antenna tilt angle downward, or move the
Joystick down to adjust the antenna tilt angle upward.