Gambro AK 95, Service Manual

Page: 84 / 247

4:11
AK 95 / AK 95 S Service Manual
HCEN 9136 Rev. 10.2005
Service Technicians Guide
Presetable parameters in Autopriming
0 Auto priming install Installed / Not installed
1 Auto priming fill flow 0 - 500 ml/min
This is the initial flow rate when
filling the dialyzer and blood lines.
2 Auto priming fill time 0 - 300 s
This is the time for filling the dialyzer
and blood lines completely.
3 Auto priming press build time 0 - 30 s
The venous clamp closes. This is the time for
building up the venous pressure alarm limit.
4 Auto priming press drop time 0 - 60 s
The measurement time for the pressure
drop when performing the leakage test
of the dialyzer.
5 Auto priming press drop 0 - 100 mmHg
The acceptable pressure drop when per-
forming the leakage test of the dialyzer.
6 Auto priming prim flow 0 - 500 ml/min
This is the flow rate during the priming
phase as well as during the flushing phases.
7 Auto priming prim time 0 - 600 s
This is the required time for the priming
phase.
8 Auto priming cycle time 0 - 60 s
This time specifies the opening and closing
time of the venous clamp during the priming
phase.
9 Auto priming level time 0 - 60 s
This is the time necessary to fill up the
venous drip chamber to a correct level.
10 Auto priming flush time 1 0 - 300 s
During this time, the remaining air in
the dialyzer and blood lines will be expelled.
11 Auto priming flush time 2 0 - 600 s
If a second flush is requested, select this time.
12 Auto priming venous line time 0 - 120 s
The time when the venous clamp is open.
In order to expell any air bubbles in the
venous line.
13 Auto priming FM active Avail / Not Avail