Fujitsu Primergy RX300 S4, User Manual

Page: 224 / 267

224
Chapter 8 Operation and Maintenance
This error results from that the LAN driver for the network adapter recognized immediately after the OS
installation is not updated.
Clicking [Finish] in this window displays the [Help and Support Center] window. Click [X] to close this
window. The "!" mark is displayed at the LAN device name in Device Manager. The device names are
displayed properly when all the LAN drivers are installed and the system is restarted.
LAN operation fails or error message appears during LAN driver
installation
A conflict may have occurred between system resources including the LAN and other expansion cards.
Delete all the LAN drivers and check that conflicts between system resources do not exist. Then, restart
the system and reinstall the LAN drivers again.
Event log errors after installation
After installation, the following events may be displayed in Event Viewer. Check and perform the
corrective action against the relevant event.
Cannot collect the memory dump
If the memory dump file cannot be created, perform the following procedures.
Correcting the settings
If the memory dump cannot be collected, check the settings of the paging file and memory dump file.
For setting procedures, refer to "4.1 Memory Dump/Paging File Setting" ( p.74).
table: List of event log errors that may occur after installation
ID Description Cause and corrective action
62 This computer is a domain PDC at the
root of forest. Use the net command
"net time /setsntp:<server name>" to
configure it for synchronization from
an external time source. Cause:
An NTP was selected as a component.
Corrective action:
ServerStart cannot configure the NTP server due to the
absence of items for specifying it. After OS installation,
perform the following procedure to specify the time server.
1. Start SNTP server operation on another machine.
For example, the SNTP server address is
<172.22.78.246>.
2. Enter the following at a Command Prompt.
net time /setsntp:172.22.78.246
w32tm -s 172.22.78.246
1000 The user or computer name cannot be
identified. The return value is "1722". Cause:
The primary DNS server address may be invalid or the server
cannot be accessed.
Corrective action:
Perform the following procedures to correct the DNS address
in Internet protocol (TCP/IP) properties.
1. Right-click [My Network] and click [Properties].
2. Right-click [Local Area Connection] and click
[Properties].
3. Click [Internet Protocol (TCP/IP)] and click
[Properties].
4. Enter the correct DNS address in the [Primary DNS
server] box.