Fujitsu Primergy RX300 S4, User Manual

Page: 151 / 267

151
PRIMERGY RX300 S4 User's Guide
5
Install or remove memory modules in the memory board.
When installing memory modules
Keep the levers on both sides of the slot where the memory module is to be installed open, and
insert the memory module vertically in the memory slot while lining up the notch.
When the memory module is properly installed, the levers on both sides of the slot are pulled
back. At this time, confirm that the memory module is secured. If the levers are not pulled back
completely, make sure the levers are pushed inwards.
When removing memory modules
Pull the levers on both sides of the slot outwards and remove the memory module.
6
Install the memory board in the memory slot.
7
Attach the fan duct.
" How to attach the fan duct" (p.138)
8
Attach the top cover and push the server back into the rack.
" How to attach the top cover" (p.137)
9
Initialize the Extended System Configuration Data (ESCD).
Set [Reset Configuration Data] to [Yes] in the [Advanced] menu of the BIOS Setup Utility.
"7.2.5 Advanced Menu" (p.190).
• If the memory module has not been correctly inserted, it may cause a fire.
Insert the memory module with attention to its direction.
• If a memory module is installed and you pull the hook strongly outwards, the
memory module pops up. Doing so may cause a device failure.
Lever
Align notch
Lever