Fujitsu Primergy RX300 S4, User Manual

Page: 25 / 267

25
PRIMERGY RX300 S4 User's Guide
1.3.2 Server (Rear View)
a Power supply unit slot 1 (installed standardly)
One power supply unit is installed by default.
b Power supply unit failure LED
The LED indicates the power supply unit status. When a failure occurs, this LED lights up amber.
c Power supply unit LED
This LED is on, depending on the power supply status as follows.
d Power supply unit slot 2 (optional)
An optional power supply unit can be installed. Up to two units can be installed.
Adding a power supply unit enables redundant power supply function.
e Mouse connector (6 pins) ( )
A mouse is plugged in.
f PCI slot
g Inlet
Power cables are plugged in.
h Rear maintenance LED / System identification LED ( )
When an error is detected in a server component, this LED lights or blinks in yellow (OFF in
normal status).
When this LED lights or blinks, contact an office listed in the "Contact Information" of the "Start
Guide".
When pressing the system identification LED button located on the front of the server, the front
and rear LEDs are lit blue so that the locations of devices being maintained can be determined.
Also, the [System Identification LED Display] button of ServerView can be used to light them.
i Keyboard connector (6 pins) ( )
A keyboard is plugged in.
table: Power supply unit status
LED status Power supply status
Lights green In normal mode (operating mode)
Lights yellow In normal mode (standby mode)
Off Power not supplied (power off)
i
e d b
n m l k j h g
a c f
o
ID