Fujitsu Primergy RX300 S4, User Manual

Page: 218 / 267

218
Chapter 8 Operation and Maintenance
Verify CPU Frequency selection in Setup The CPU is abnormal. Power off the server and turn it back on.
If the message still appears, check the error log and replace the
CPU if it is at fault. Or the baseboard must be replaced. Contact
an office listed in the "Contact Information" of the "Start
Guide".
System Management Configuration changed If this is displayed right after changing the hardware
configuration, disregard it. If the same message is displayed
again, confirm the cable is correctly connected and change the
[Reset Configuration Data] setting to [Yes] on the "7.2.5
Advanced Menu" (
p.190) of the BIOS Setup Utility.
Invalid System Configuration Data The system configuration is abnormal. Check that the
configuration is supported. If the message still appears even
though the configuration is supported, the baseboard must be
replaced. Contact an office listed in the "Contact Information"
of the "Start Guide".
Operating system not found
The OS used for start up cannot be found. Check that the cables
of each device are connected correctly. Or check that SAS/
RAID recognizes the device normally during POST.
Check the [Boot Sequence] setting on the "7.2.4 Boot Options
Submenu" (
p.188) in the [Main] menu of the BIOS Setup
Utility. If the message still appears, the baseboard must be
replaced. Contact an office listed in the "Contact Information"
of the "Start Guide".
Patch for installed CPU not loaded. Please run
the bios flash update diskette. Check that the correct CPU is installed. If the correct CPU is
installed and the message still appears, BIOS requires to be
updated. Update the BIOS using updating tool supplied with
new CPU. If the message still appears, select [Yes] for the
[Reset Configuration Data] setting on the "7.2.5 Advanced
Menu" (
p.190) of the BIOS Setup Utility. Nevertheless, if the
message still appears, the baseboard must be replaced. Contact
an office listed in the "Contact Information" of "Start Guide".
PCI system error BUS/DEVICE/FUNCTON
xxxxh The expansion card is abnormal. Replace the expansion card. If
the message still appears, the baseboard must be replaced.
Contact an office listed in the "Contact Information" of the
"Start Guide".
CPU had been changed - Run setup
The CPU has been replaced. This message appears after the
baseboard or CPU is replaced. Select [Yes] for the [Reset
Configuration Data] setting on the "7.2.5 Advanced Menu"
(
p.190) of the BIOS Setup Utility.
No usable CPU Installed CPU error. Replace the CPU. If the message still
appears, the baseboard must be replaced. Contact an office listed
in the "Contact Information" of "Start Guide".
No usable system memory
Memory error. Check the error log and replace the memory
module. If the message still appears, the baseboard must be
replaced. Contact an office listed in the "Contact Information"
of "Start Guide".
Memory Redundancy Feature could not
configure the Mirror DIMMs Memory Mirroring cannot be configured. Confirm that the
memory bank that configures the mirror is the same capacity. If
the memory is installed properly, it must be replaced.
Memory Redundancy Feature could not
configure the spare DIMMs
Memory sparing cannot be configured. Confirm that the
memory bank that configures the spare is the same capacity or
larger. If the memory is installed properly, it must be replaced.
table: List of POST error messages
Message Description