Fujitsu Primergy RX300 S4, User Manual

Page: 239 / 267

239
PRIMERGY RX300 S4 User's Guide
6
Perform the settings as required, and click [Next].
The restoration settings completion window appears.
7
Click [Finish].
The restoration start window appears.
8
Check the checkbox, and click [OK].
System restoration starts.
After the restoration has completed, the system is automatically rebooted. After rebooting, the
system is restored using the backup data.
For operation with a BitLocker drive encryption set, perform the encryption settings again after
the system restoration.
8.6.2 For Windows Server 2003
For Windows Server 2003, only the system file, system configuration, or environment changes during
startup can be restored by using Automated System Recovery set.
Items required
• Windows Server 2003 CD-ROM
• Automated System Recovery floppy disk (created beforehand)
• Backup media (created beforehand)
• Driver disk (for array controller card)
For drivers to be used and how to create driver disks, refer to "4.4 Creating Maintenance Tools and
Driver Disks" ( p.88).
1
Insert the Windows Server 2003 CD-ROM (installation disc) immediately after
the server is turned on.
Check that a floppy disk is not inserted in the floppy disk drive.
2
When an active area is set on the hard disk, the following message is displayed
at the bottom of the screen. Press any key while the message is displayed.
The Windows Server 2003 setup screen appears.
Press any key to boot from CD...