Fujitsu Primergy RX300 S4, User Manual

Page: 123 / 267

123
PRIMERGY RX300 S4 User's Guide
4.7.3 VLAN
Notes
The following are notes on using VLAN via Intel
®
PROSet. For details, refer to Intel
®
PROSet help.
However, when the content of help and this manual differ, follow the instructions in this manual.
• Up to four VLANs whose "NetBIOS over TCP/IP" is enabled in the whole system.
• Only ten or less VLANs can be set to a LAN port.
• When adding or deleting a VLAN, always use "Intel(R) PROSet". Do not disable or delete a VLAN
from the [Device Manager] or [Network Connections].
• On a VLAN, only use IP protocols.
When LLC and the LNDFC protocols are installed by the Fujitsu communication control service,
these protocols are bound (connected) unconditionally. Therefore, release the bind of VLAN and
these protocols in the system where these protocols and VLAN are installed at the same time.
Creating a VLAN
1
Click [Start] – [Administrative Tools] – [Computer Management] to start Intel
®
PROSet.
2
Click [Network adapters] under [Device Manager] and double-click a LAN card
to setup a VLAN.
3
Click the [VLANs] tab, and click [New...].
4
Specify [VLAN ID] and [VLAN Name]. Then click [OK].
The [VLAN ID] should be identical to the switch setting. 1 to 4094 can be specified.
Any name can be specified as the [VLAN Name].
5
Click [OK] to close the property window for the LAN adapter.
When setup of the VLAN is complete, the following virtual adapter will be created.
• "(LAN Adapter Name)-VLAN:(VLAN Name)"
Upper protocols will be bound with the main virtual adapter. They cannot be bound with the LAN
card configuring a VLAN. The IP address should be specified in the main virtual adapter.