Fujitsu fi-7300NX, Operator'S Manual

Page: 279 / 321

Shortening the Scanning Intervals [Pre-Pick]
Enable this to shorten the scanning time when scanning continuously.
"Pre-pick" refers to feeding the next document into the ADF before ejecting the current document being scanned
when scanning documents continuously.
1
Start up the Software Operation Panel.
For details, refer to
Starting Up the Software Operation Panel (page 248) .
2
From the listing on the left, select [Device Setting 2] → [Pre-Pick].
3
Specify whether or not to enable pre-pick.
Select [Yes] or [No].
The factory default setting is [Yes].
HINT
●
If you cancel in the middle of scanning while pre-pick is enabled, you have to remove the pre-picked
document, then load the document again.
● This setting can also be configured in the scanner driver.
Note that priority is given to the scanner driver setting.
Scanner Settings (Software Operation Panel)
279