Fujitsu fi-7300NX, Operator'S Manual

Page: 232 / 321

Paper Source/Feeding
Pre-Pick
Enable this to shorten the scanning time when scanning continuously.
"Pre-pick" refers to feeding the next document into the ADF before ejecting the current document being
scanned when scanning documents continuously.
Enable
[Enable] is set to on as the factory default.
HINT
●
If you cancel in the middle of scanning while pre-pick is enabled, you have to remove the pre-
picked document, then load the document again.
● This setting can also be configured in the scanner driver.
Note that priority is given to the scanner driver setting.
Retry Paper Feeding
Specify the number of feeding retries when a document is not fed from the ADF paper chute (feeder).
Number of paper feeding retries
The factory default setting is "3".
Multifeed Detection
Multifeed is an error that occurs when two or more sheets are overlapped and fed at once.
Configure the settings to detect overlapped documents during a scan.
Overlapped documents are detected with the ultrasonic sensor or according to the difference in length of
the documents.
When overlapped documents are detected, an error message is displayed on the touch screen and the
scan stops. If documents are overlapped within 30 mm from the leading edge, they are not detected as
overlapped.
Detection Method
Specify a method to detect overlapped documents.
● Does not detect
Does not detect overlapped documents.
This is the factory default setting.
● Check Overlapping (Ultrasonic)
Detects overlapped documents with the ultrasonic sensor.
When this is selected, you can specify the following two options:
- Specify an area to detect overlapped documents by the length from the leading edge of the
document in the feeding direction.
Set it in [Multifeed Detection Area].
Scanner Settings (Touch Screen)
232