Fujitsu fi-7300NX, Operator'S Manual

Page: 235 / 321

Configure the setting so that the value of the end position minus the start position is 6 mm or more.
●
For examples of the overlapping detection area settings, refer to Examples of the Settings for the
Area to Detect the Overlapping of Documents (page 296) .
Intelligent Multifeed Detection
Configure the setting to automatically ignore certain patterns of overlapped documents when the setting
to detect overlapped documents is enabled.
Note that you first need to specify [Check Overlapping (Ultrasonic)] or [Check Overlapping and Length] in
the scanner driver and "
Multifeed Detection (page 232) " on the touch screen before setting this item.
Operation mode
Set the operation mode.
Manually Bypass
Specify whether overlapped documents are detected when re-scanning documents detected as
overlapped documents.
Does not memorize the size or location of the paper attachment.
This is the factory default setting.
Automatically Bypass (combination of length and position)
Specify whether the length and position of a piece of paper attached on a document detected as
overlapped documents are memorized as an overlap pattern.
If the overlap pattern is memorized, documents with the same overlap pattern are not detected
as overlapped documents from the next scan.
HINT
Eight of the most recent overlap patterns can be memorized when [When powering off] in
[Memorize overlap pattern] is enabled.
Automatically Bypass (length)
Specify whether the length of the longest piece of paper attached on a document detected as
overlapped documents is memorized as an overlap pattern.
If the overlap pattern is memorized, a document with a piece of paper in the same length or
shorter attached is not detected as overlapped documents from the next scan.
Memorize overlap pattern
When confirming image
Specify whether or not to memorize overlap patterns automatically when the window is
displayed to check images for documents that were detected as overlapped documents.
[When confirming image] is set to off as the factory default.
When powering off
Specify whether or not to keep overlap patterns upon turning the power off.
Scanner Settings (Touch Screen)
235