Motor Circuit Error
Motor Circuit Error
When a motor circuit error occurs, the [Error] screen on the touch screen displays one of the following codes.
H0:84 Motor circuit error
If the problem persists after turning the power back on, please inform your service provider of the
error code below.
Code H0:84
H1:80 Motor circuit error
If the problem persists after turning the power back on, please inform your service provider of the
error code below.
Code H1:80
H2:81 Motor circuit error
If the problem persists after turning the power back on, please inform your service provider of the
error code below.
Code H2:81
H8:88 Motor circuit error
If the problem persists after turning the power back on, please inform your service provider of the
error code below.
Code H8:88
Turn the scanner off then back on.
If the problem persists, write down the error code and contact the distributor/dealer where you purchased this
product. Refer to the contact information in the Contact List if supplied with this product, or refer to the contact
information in the Contact for Inquiries section if provided in Safety Precautions supplied with this product, and
then make an inquiry.
Lamp Circuit Error
When a lamp circuit error occurs, the [Error] screen on the touch screen displays the following code.
H7:84 Lamp circuit error
If the problem persists after turning the power back on, please inform your service provider of the
error code below.
Code H7:84
Turn the scanner off then back on.
If the problem persists, write down the error code and contact the distributor/dealer where you purchased this
product. Refer to the contact information in the Contact List if supplied with this product, or refer to the contact
information in the Contact for Inquiries section if provided in Safety Precautions supplied with this product, and
then make an inquiry.
Troubleshooting
154
Summary of Contents for fi-7300NX
