213
PRIMERGY RX100 S4 User’s Guide
8
Co
nf
igurin
g Hardwa
re and Utili
tie
s
8.2.6 Peripheral Configuration Submenu
This submenu appears when selecting "Peripheral Configuration" in the [Advanced] menu.
Use this submenu to configure the serial port, etc.
table: Items on the Peripheral Configuration Submenu
Item
Setting
Description
Serial 1
• Disabled
• Enabled
• Auto (At the time of
purchase)
• OS Controlled
Sets to enable or disable the serial port.
Set this to "Disabled" to use as a server
management port.
Note:
When [Serial Multiplexer] is changed to
"iRMC", set this item to "Disabled".
Serial 1 Address
3F8h, IRQ 4
(Unchangeable)
Configures I/O port address for Serial Port 1.
Appears when "Enabled" is selected for [Serial 1].
Serial Multiplexer
• System (At the time of
purchase)
• iRMC
Switches the function of serial port 1.
• System
Uses this port as a serial port (Setting at the time
of UPS connection).
• iRMC
Uses this port as a server management port. In
this case, set [Serial 1] to "Disabled".
USB Enable Ports
All (Unchangeable)
Sets to use the USB port or not.
USB 2.0 Host Controller
Enabled (Unchangeable)
Sets to enable the USB controller (2.0 standard) or
not.
USB BIOS Supported
Devices
Auto (Unchangeable)
Sets if the USB device can be used on the OS that
does not support USB.
USB Boot Delay
0 s (Unchangeable)
Sets the delay time, by the second, for initializing
USB mass storage device during POST.
ATA Controller Config
Press the [Enter] key to display the [ATA Controller Config] submenu. These items
cannot be changed.
S-ATA Mode
Native (Unchangeable)
Sets the serial ATA operation mode.
Item Specific Help
Change Values
Enter
F9
Select Item
Select Menu
Select Sub-Menu
-/+
F1
Esc
Help
Exit
F10
Setup Defaults
Save and Exit
Advanced
Security
Server
Exit
Main
Peripheral Configuration
Serial 1:
Serial Multiplexer:
USB Enable Ports:
USB 2.0 Host Controller:
USB BIOS Supported Devices:
USB Boot Delay:
ATA Controller Config
Mouse Controller:
LAN Controller:
[Auto]
[System]
[All]
[Enabled]
[Auto]
[0 s]
[Auto Detect]
[LAN1&2]
LAN1 Remote Boot:
[Disabled]
LAN2 Remote Boot:
[Disabled]
