Foma SO903i, Manual

Page: 42 / 384

39
Before Using the FOMA Terminal
● If you perform the Reset all data&set or do not change the Security code of the FOMA terminal or Location
request setting, the message “Initial setting is incomplete. Execute?” appears when you power on the
FOMA terminal. When you select [Yes], the display in step 1 appears and you can perform the initial setting.
Setting the Date and Time
<Date/time>
Default Auto time set: ON
You can set the date and time of the FOMA terminal either by automatically correcting
the time of the FOMA terminal based on the time information obtained from the DoCoMo
network or by manually setting the time.
Example: Correcting the time automatically
1
From the Menu, select [Settings] → [Management] → [Date/time] and press .
Ａｕｔｏ ｔｉｍｅ ｓｅｔ
ＯＮ
Ｍａｎｕａｌ ｃｌｏｃｋ ｓｅｔ
Ｄａｔｅ／ｔｉｍｅ
[Auto time set] : Set the time automatically.
[Manual clock set] :
Enter the time manually. When you set the time using the
Manual clock set, the Auto time set is set to [OFF].
2
Select [ON] at [Auto time set].
[ON] : Correct the date and time automatically.
[OFF] : Do not correct the date and time automatically. Set the time using the Manual clock set.
To set the time manually
Select [Manual clock set] → [Yes] and enter the year and date within the range from
2000/01/01 to 2050/12/31, and the time in 24-hour format (00:00 to 23:59). Press
(Complete).
● When you set the Auto time set to [ON], the date and time are corrected automatically when the FOMA
terminal is powered on with a UIM installed. Note, however, that there may be an error lasting several
seconds. The time cannot be automatically corrected in the following cases.
- Outside of the service area (The time may not be corrected automatically even inside the service area
depending on the radio wave condition.)
- While i-
α
ppli is running
● The date and time settings are retained even when you replace the battery pack. However, if you leave the
FOMA terminal without a battery pack or with a fully expended battery pack for a long period of time, the
date and time may be reset to “----/--/-- --- --:--”. In this case, set the date and time once again.
● If the date and time are not set, functions that use the clock, such as the current time icon, Schedule, Alarm,
i- α ppli Auto start, and calendar/clock display cannot be used. The date and time for the Redial/Received
record and the date and time on images shot with the camera are also not recorded.
● When you get time correction information from the network of the carrier to which the FOMA terminal
is connected during international roaming, a message for confirming whether the time is automatically
corrected appears. Select [Yes] to correct the time automatically. The current local time is displayed. If you
select [No], the time is not corrected.
When the time is corrected to the local time, the date and time used for the Redial/Received record and
sent/received mail also are corrected to the local time and “
” appears next to the date. Note, however,
that some overseas networks may not perform time correction.
● If you leave the time correction function on when you return to Japan and select [No] to the message for
confirming whether the time is corrected, only the sub-clock display is canceled. To set the correct time,
power off the FOMA terminal and power it on again.