Foma SO903i, Manual

Page: 174 / 384

171
i-mode/i-motion/i-Channel
Displaying the i-Channel
1
Press (i.ch) in the stand-by display.
The channel list appears.
2
Select a channel and press .
● You may receive specific information when the channel list
is displayed, depending on the terms of use.
When You Receive i-Channel
Main display
→ 最高１０℃ １０
When you receive information, the
information is automatically run as
Telop text on the stand-by display.
To display the channel list
Press (i.ch).
Telop
Sub-display
→ 最高１０℃ １０％ Telop
● When you receive i-Channel information, “ ” → “ ” flashes.
Even if you receive information, the FOMA terminal does
not sound the ring tone or vibrate, and the incoming
indicator does not operate, either.
● If you change the host, the Telop text may be turned off
and information may not be automatically updated. To
receive latest information, press
(i.ch) and display the
channel list. The Telop text starts running automatically.
●
You can change the i-Channel host using the Host
selection (P.164). Normally, you do not need to change the
host.
● When the FOMA terminal is powered off, outside of the
service area, or in poor radio wave condition, you may
not be able to receive information. When you receive
information by pressing
(i.ch), the Telop text is
automatically displayed in the stand-by display.
● Telop text is not displayed in the following cases.
- When the Lock all is set
- When the PIM lock is set
- When the Omakase Lock is set
- When the Public mode (Driving mode) is set
- When the UIM is not inserted
- When the i-Channel or i-mode service is canceled