Foma SO903i, Manual

Page: 60 / 384

57
Voice/Videophone Call
Placing a Call by Specifying a Sub-address
<Sub-address>
Default ON
You can set to place a call to a specific phone or communication device by specifying a
sub-address.

The sub-address is also used when you select a content in V-Live.
1
From the Menu, select [Settings]
→
[Call]
→
[Call assist]
→
[Sub-address] and
press .
[ON] : Recognize the numbers after “ ” as a sub-address.
[OFF] : Do not recognize the numbers after “ ” as a sub-address.
2
Select [ON]/[OFF] and press .
The Sub-address is set.
To place a call by specifying a sub-address
In the stand-by display, enter a phone + sub-address and press either or
(V.phone).
● Even if the Sub-address is set to ON, “ ” is not recognized as the sub-address separator but as part of a
phone number in the following cases: where it is at the beginning of a phone number and immediately after
a number entered using Prefix/Int’l prefix/Country code of the Call menu.
Setting the Alarm When Reconnecting a Dropped Call
<Reconnect alarm>
Default High
This function automatically reconnects the call interrupted during a voice, videophone, or
PushTalk call due to the radio wave condition, such as in a tunnel or between buildings,
right after the radio wave condition is recovered. You can set an alarm tone when a call
is reconnected.
1
From the Menu, select [Settings] → [Call] → [Call setting] → [Recnct ALM] and
press .
[High] : Sound the high alarm tone.
[Low] : Sound the low alarm tone.
[OFF] : Do not sound the alarm tone.
2
Select the type of the alarm tone and press .
The alarm tone during reconnection is set.
● The recipient does not hear any sound while the radio wave is interrupted.
●
The time required for reconnection depends on the usage and radio wave condition. The average
reconnection time is about 10 seconds and the caller is charged for the time spent for reconnection.