Flintec FT-111 AN, Technical Manual

Page: 138 / 146

FT-111(D) Panel Weighing Indicator, Technical Manual, Rev.1.0.0, May 2019 Page 137 of 146
10100 20
Not used
10101
21
SetPoint-1 Low
Only available for Threshold and
Window feature.
Refer to sub-block 36-, page 59
to see the availabilities.
10110
22 SetPoint-2 Low
10111
23 SetPoint-3 Low
11000
24
SetPoint-4 Low
11001
25 SetPoint-5 Low
11010
11110 26
30
Not used
11111 31
Use the Expanded Command list
( Refer to Table 12-3 )
B37 ... B33
Read Data
Selection
00000 0 Actual weight ( Net if the indication is in Net )
00001 1 Gross weight
00010 2 Tare weight
00011 3 ALL Status ( Refer to Table 12-1 )
00100 4
Calibration Status ( Refer to
Table 12-2
)
00101 5 Last print value
00110
01010 6
10
Not used
01011 11 CN (Label number)
01100
01110 12
14
Not used
01111 15 Set Point-1 (High)
10000 16 Set Point-2 (High)
10001 17
Set Point-3 (High)
10010 18
Set Point-4 (High)
10011 19
Set Point-5 (High)
10100 20
Not used
10101
21 SetPoint-1 Low
Only available for Threshold and
Window feature.
Refer to sub-block 36-, page 59
to see the availabilities.
10110
22 SetPoint-2 Low
10111
23 SetPoint-3 Low
11000
24
SetPoint-4 Low
11001
25
SetPoint-5 Low
11010
11110 26
30
Not used
11111 31
Use the Expanded Command list
( Refer to Table 12-3 )
B32 New CMD Toggle Apply commands which are listed in this table.
B31-B0 B37-B33 bits defines the usage of this Dword.
(1) Write this command after writing values to Low Dword of RxPDO then apply this command with New CMD.