Festo DLP-VSE Series, Manual

Page: 9 / 112

Contents and general instructions
VII
Festo P.BE-DLP-VSE-... en 0206a
Intended use
The Local control unit described in this documentation is in-
tended exclusively for use in process control. In conjunction
with additional commercially available components, such as
sensors and actuators, the specified limits for pressures, tem-
peratures, electrical data, torques etc. must be observed.
Please comply with national and local safety laws and regula-
tions.
Target group
These operating instructions are intended exclusively for
qualified personnel who have experience in installing and
commissioning automation and control devices. For the vari-
ants DLP-VSE-...-DP and ...-ASI, knowledge of programming
and diagnosing PROFIBUS-DP or AS-Interface slaves is also
required.
The Local control unit is intended for use in controlling servo
drives on valves and flap valves of the process controller,
referred to in the following as fittings.
Notes on these operating instructions
These operating instructions contain specific information on
fitting, installing and commissioning the Festo Local control
unit, as well as on programming and diagnosing the Local
control unit as a slave on the PROFIBUS-DP or AS-Interface.
AS-Interface
®
is an internationally protected trade mark.