Festo DLP-VSE Series, Manual

Page: 21 / 112

2. Fitting
2-1
Festo P.BE-DLP-VSE-... en 0206a
2. Fitting
Caution
Compare the maximum values specified with those of your
application. The permitted maximum values, e.g. for pres-
sures, forces, torques, masses, speeds and temperatures
must not be exceeded. Make sure that the cables between
the Local control unit and the fittings are kept as short as
possible.
Please note
Before fitting the Local control unit, you must order the
following parts separately:
– a suitable sub-base type DLP-VSE-AP or DLP-VSE-NA.
(further information see chapter 2.2)
– if fitted onto a wall, the fastening kit DLP-VSE-BP (see
chapter 2.1)
2.1 Fitting onto a wall
Caution
Make sure that the fastening surface can support the
weight of the Local control unit.
S
Prepare the Local control unit for fitting with sliding
blocks as follows (Fig. 2/5):
1. Remove the protective foil from the air channels.
2. Insert the sliding blocks
3. Fit the end cover. Tighten the cover screws with 1.5 Nm
(± 20%).