Chapter: 6
Section:
Page
1
PROGRAM EXECUTION
INTRODUCTION
6.
PROGRAM EXECUTION
6.1 INTRODUCTION
The VNP400 permits the storing of up to 10 part-programs which can be Executed later on
by the machine. Each program can contain any number of blocks as long as the total number
of blocks for all programs does not exceed 500.
Indicate the number of the program stored in memory which is to be executed. If the
program does not exist, the DRO will display the corresponding message.
The active reference point as well as the display format INCH/MM or DEG/DMS must be
selected before selecting the execution mode.
The coordinate type ABS/INC will be selected automatically and they will depend on the
value assigned to the STATUS parameter when editing the program.
It is possible to change the display format INCH/MM or DEG/DMS during the execution
of the program by pressing the corresponding key.
Summary of Contents for VNP400
Page 1: ...FAGOR VNP400 Ref 9506 in...
