Page
Chapter: 4
Section:
DRO MODE OF OPERATION
14
R
Indicates the RPMs of the spindle.
If a value is assigned to this parameter, the DRO will calculate the cutting speed
for point “P” in meters/min. or feet/min. (depending on the units selected for “V”).
If, on the other hand, the rpms are to be calculated, then, this parameter must be
unassigned and the “V” value will have to be defined.
Press the EXIT softkey to quit this mode during or after this operation.
When pressing the CALC softkey, the DRO will calculate the value of the requested
variable and it will display it next to the other parameters.
If the cutting speed “V” at the cutting point “P” was requested, the DRO will display
the required units, meters/min or feet/min ignoring the action of the CHANGE UNIT
softkey.
Press the EXIT softkey to return to the standard display.
RPM CALCULATION
Summary of Contents for VNP400
Page 1: ...FAGOR VNP400 Ref 9506 in...
