Chapter: 4
Section:
Page
DRO MODE OF OPERATION
19
4.- To enter the last operand, key in the figure as point 1 and then press
.
The entered number goes into the operations memory area and the total result of
the indicated operations appears below it.
This result is again shown in the data entry area to be used in the next operation.
5.- Do the same to perform more operations.
The
key resets the calculator deleting the operations memory area and
entering a 0 in the data entry area.
The DRO stores the result of the last operation in its internal memory so it can be
recalled for the next calculator operation or when presetting a value in one of the DRO
axes.
To preset an axis with this value, follow these steps:
*
Press the softkey corresponding to the axis to be preset.
*
Press
. The result of the last operation will be shown as the axis position value
to be preset.
*
Press
. The axis position is preset with this value.
Note: Every time the DRO is powered off and back on, it takes the value of 0 as the
result of the last operation.
CALCULATOR FUNCTION
Summary of Contents for VNP400
Page 1: ...FAGOR VNP400 Ref 9506 in...
