Fagor 8025 GP, Operating Manual

Page: 72 / 423

8025/8030 CNC OPERATING MANUAL 45
3.6.6. Selection of a program
- If the number of the required program is the one which appears on the screen when the EDIT
operating mode is selected, to obtain it just press [CONTINUE].
- If a different program is wanted :
- Press the [PROGRAM SELECTION] key.
- Key in the program number.
- Press [CONTINUE]. The program selected will appear on the screen.
3.6.7. Creating a program
If there is a program in the CNC’s memory with the same number as the one to be recorded, there
are two methods for recording the new program:
- Completely erase the existing program.
- Not to erase it and write it block by block (as described further on) over the existing program,
taking care to assign the same numbering as the previously recorded blocks to the blocks being
written.If there is no other program in memory with the same number, proceed as follows:
3.6.7.1 Displaying the block contents
To scroll the blocks being displayed up and down:
- Press : The display scrolls up one line (block).
- Press : The display scrolls down one line (block).
On models with 512 Kb of part-program memory (models: MK, MGK, MSK, GPK, MIK,
MGIK, MSIK, GPIK), the following keys and softkeys are also available:
- Press : The display scrolls up 5 lines (blocks).
- Press : The display scrolls down 5 lines (blocks).
- Press [BEGIN] : The display shows the first blocks.
- Press [END] : The display shows the last blocks.