Fagor 8025 GP, Operating Manual

Page: 71 / 423

44 8025/8030 CNC OPERATING MANUAL
3.6.4. Change of program number
- Press [PROG RENAME]. The screen will display:
OLD:P
- Key in the existing number of the program whose number is to be modified. It will be
displayed to the right of P.
- Press ENTER. The screen will then display:
NEW: P
- Key in the new number allocated to this program. It will be displayed to the right of P.
- Press ENTER. The change of number has been completed.
If there is no program recorded under the old number, the screen will display:
PROGRAM NUMBER: P ——-
DOES NOT EXIST IN MEMORY
- If there is a program already with that number, the screen will display:
ALREADY EXISTS IN MEMORY.
Atention:
During this sequence if the [CONTINUE] key is pressed, access is obtained
to the original display of this MODE.
3.6.5. Display and search of subroutines stored in memory
- By pressing [STANDARD SUBROUTINE DIRECTORY] or [PARAMETER SUB-
ROUTINE DIRECTORY] all the subroutines, standard or parametric, recorded in the
CNC memory are displayed.
- To find out which programs contain the subroutines displayed on the screen, key in the
subroutine number and press RECALL.
The number of the program where this subroutine is found will appear on screen.
To repeat the process for another subroutine, press DELETE or the [SUBRTS] key and
repeat the previous sequence.
Atention:
During this sequence, if the [CONTINUE] key is pressed, the access is gained
to the original display of this MODE.