Fagor 8025 GP, Operating Manual

Page: 355 / 423

8025/8030 CNC PROGRAMMING MANUAL 235
Example:
N5 M23
N10 M24
Block N5. The CNC sends out M21 if P605(3) and will place the just machined part in
unloading position by moving the axes W,X and Z to the positions set by P904, P905 and
P906. Then it will send out the code M23 so that the interface executes the unloading
sequence.
If parameter P711, corresponding to M23, has a value of 5, the CNC will execute
subroutine number 5.
Block N10. The CNC will place the machine ready to load the new part by moving the axis
W,X and Z to the position set by P904,P906 and P907. Then it will send out the code M24
so that the interface executes the loading sequence.
If parameter P712, corresponding to M24, has a value 0, the sequence is now finished.
The sequence described is executed in modes AUTOMATIC, SINGLE BLOCK, and
TEACH-IN. In SINGLE BLOCK mode, the
key must be pressed as many times as
different operations there are.
In JOG mode, the CNC will move the last axis X, or Z and then it will send the relevant
code (M22,M23,M24,M25) if the axis W, or W and X were previously positioned.
Otherwise if will give error code 51.
No other information can be programmed in a block containing M22,M23,M24 or M25.