Fagor 8025 GP, Operating Manual

Page: 233 / 423

8025/8030 CNC PROGRAMMING MANUAL 113
The probe’s movements will be the following:
Let us suppose that the main plain is XY and the outside edge to be measured is the lower
lefthand edge of the part and the inclination angle of the part with respect to the axes of the
machine (see fig.).
1. The probe will be positioned in rapid at a distance 2P3 of the first side to be measured.
2. The axis perpendicular to the main plane, in this case Z, will move in rapid to a
position defined by P2.
3. The first probing will be performed by moving the X axis a maximum distance of
3P3 at a feedrate defined by P4 until the probe’s signal is received.
4. Once the first probing is done, the measured value will be loaded and then the X axis
will return in rapid.
5 and 6. Next, the probe will be positioned in rapid at a distance 2P3 of the other side to be
measured, as shown by the diagram.
7. The second probing will be performed by moving the Y axis a maximum distance
of 3P3 at a feedrate defined by P4 until the probe’s signal is received.
8. Once the second probing is done, the measured valuewill be loaded and then the Y
axis will return in rapid.
9. The X axis will move an incremental distance P3 in rapid.
10. The third probing will be performed at a feedrate defined by P4 and to a maximum
distance of 4P3.
11. The Y axis will return in rapid.
12. The Z axis will return in rapid to the Z value of the starting point.
13. The X and Y axis will return in rapid to the starting point.
Atention:
In any of the rapid probing movements (3), (7), (10), if after reaching the
maximum distance (3P3), (3P3), (4P3) the CNC has not received the probe’s
signal, error 65 will be displayed.