Fagor 8025 GP, Operating Manual

Page: 370 / 423

250 8025/8030 CNC PROGRAMMING MANUAL
i) N4P1 = 0Y
P1 takes the theoretical coordinate of the Y axis, with respect to the machine zero where
the CNC is situated.
j) N4P1 = 0Z
P1 takes the theoretical coordinate of the Z axis, with respect to the machine zero where
the CNC is situated.
k) N4P1 = 0W
P1 takes the theoretical coordinate of the 4th W axis, with respect to the machine zero
where the CNC is situated.
l) N4P1 = 0V
P1 takes the theoretical coordinate of the 5th V axis,with respect to the machine zero
where the CNC is situated.
In these last assignments, the measuring units taken by arithmetic parameter, depend
upon the value assigned to the machine parameter P618(8).
If we assign the value 1 to this machine parameter, when the assignment parameter block
is executed, of the P1 = 0X type: P1 takes the value of the X coordinate, with respect to
the machine zero point, either in millimeters or inches, depending on the units of measure
used.
Nevertheless, if we assign the value 0, when P1=0X is executed, P1 takes the value of
the X coordinate with respect to the machine zero, always in millimeters, without taking
into consideration the units of measure which are being used (mm or inches).
If any of the axes are ROTARY, the value taken by the parameter will always be in
degrees.
m)N4P1 = H (Value in HEXADECIMAL)
P1 takes the value in HEXADECIMAL indicated after H.
Possible values of H: 0/FFFFFFFF.