Fagor 8025 GP, Operating Manual

Page: 96 / 423

024 The decimal point is missing when programming T2.2 or N2.2.
025 Error in a definition block or subroutine call, or when defining either conditional or unconditional jumps.
026 This error is issued in the following cases:
> Memory overflow.
> Not enough free tape or CNC memory to store the part-program.
027 I/J/K has not been defined for a circular interpolation or thread.
028 An attempt has been made to select a tool offset at the tool table or a non-existent external tool (the number of
tools is set by machine parameter).
029 Too large a value assigned to a function.
This error is often issued when programming an F value in mm/min (inch/min) and, then, switching to work in
mm/rev (inch/rev) without changing the F value.
030 The programmed G function does not exist.
031 Tool radius value too large.
032 Tool radius value too large.
033 A movement of over 8388 mm or 330.26 inches has been programmed.
Example: Being the X axis position X-5000, if we want to move it to point X5000, the CNC will issue error
33 when programming the block N10 X5000 since the programmed move will be:
5000 - (-5000) = 10000 mm.
In order to make this move without issuing this error, it must be carried out in two stages as indicated
below:
N10 X0 ; 5000 mm move
N10 X5000 ; 5000 mm move
034 S or F value too large.
035 Not enough information for corner rounding, chamfering or compensation.
036 Repeated subroutine.
037 Function M19 programmed incorrectly.