Fagor 8025 GP, Operating Manual

Page: 79 / 423

52 8025/8030 CNC OPERATING MANUAL
b) The program selected does not exist on the tape.
On starting to transfer from the cassette, if the program does not exist on the tape:
DOES NOT EXIST IN THE CASSETTE
- Press [CONTINUE]. It returns to the status of section 3.7.1. or,
- Press OP MODE. The operating mode menu will appear.
c) The program selected exists on the tape and not in the CNC memory.
The transfer is carried out normally. During this process the screen will display:
RECEIVING
- If in the program being read there is any erroneous block number (example, Nxxxxx)
the screen will display:
PROGRAM NUMBER: P —— RECEIVED
INCORRECT DATA RECEIVED
N xxxxx
In this case, only the part of the program up to the erroneous block is memorized. It
is recommended to delete the whole program.
- If the numbering of the blocks of the program transferred is correct:
PROGRAM NUMBER: P —— RECEIVED
That means that the CNC carries out a syntactic test of the program. If there is any
programming error the relevant error code and the affected block are displayed and the
program is loaded completely.
d) If the part program memory is locked, or the machine- parameters memory in case of
(P99999), the status in section 3.7.1. is re-established.