Fagor 8025 GP, Operating Manual

Page: 227 / 423

8025/8030 CNC PROGRAMMING MANUAL 107
The probe’s movements will be the following:
Let us suppose that the main plain is XY and the edge to be measured is the upper righthand
edge of the part (see fig.).
1. The probe will be positioned in rapid at a distance P3 of the first side to be measured.
2. The axis perpendicular to the main plane, in this case Z, will move in rapid to a coordinate
value defined by P2.
3. The first probing will be performed by moving the X axis a maximum distance of 2P3 at
a feedrate defined by P4 until the probe’s signal is received. If, afterreaching the maximum
distance 2P3, the CNC has not received the probe’s signal, error 65 will be displayed.
4. Once the first probing is done, the measured value will be loaded and then the X axis will
return in rapid. Next, the probe will be positioned in rapid at a distance P3 of the other side
to be measured as shown by the diagram.
5. The second probing will be performed by moving the Y axis a maximum distance of 2P3
at a feedrate defined by P4 until the probe’s signal is received. If, after moving the
maximum distance, the CNC has not received the probe’s signal, error 65 will be displayed.
6. Once the second probing is done, the measured value will be loaded and then the Y axis will
return in rapid.
7. The Z axis will move in rapid up to the Z value of the cycle’s starting point.
8. X and Y axes will return in rapid to the cycle’s starting point.