Fagor 8025 GP, Operating Manual

Page: 95 / 423

001 This error occurs in the following cases:
> When the first character of the block to be executed is not an "N".
> When while BACKGROUND editing, the program in execution calls a subroutine located in the program
being edited or in a later program.
The order in which the part-programs are stored in memory are shown in the part-program directory. If during
the execution of a program, a new one is edited, this new one will be placed at the end of the list.
002 Too many digits when defining a function in general.
003 A negative value has been assigned to a function which does not accept the (-) sign or an incorrect value has
been given to a canned cycle parameter.
004 A canned cycle has been defined while function G02, G03 or G33 was active.
005 Parametric block programmed wrong.
006 There are more than 10 parameters affected in a block.
007 Division by zero.
008 Square root of a negative number.
009 Parameter value too large
010 M41, M42, M43 or M44 has been programmed.
011 More than 7 "M" functions in a block.
012 This error occurs in the following cases:
> Function G50 is programmed wrong
> Tool dimension values too large.
> Zero offset values ( G53/G59 ) too large.
013 Cycle defined incorrectly.
014 A block has been programmed which is incorrect either by itself or in relation with the program history up to
that instant.
015 Functions G20, G21, G22, G23, G24, G25, G26, G27, G28, G29, G30, G31, G32, G50, G52, G53, G54, G55,
G56, G57, G58, G59, G72, G73, G74, G92 and G93 must be programmed alone in a block.
016 The called subroutine or block does not exist or the block searched by means of special function F17 does not
exist.
017 This error is issued in the following cases:
> Negative or too large thread pitch value.
> Function G95 or M19 has been used with machine parameter "P800=0".
018 Error in blocks where the points are defined by means of angle-angle or angle-coordinate.
019 This error is issued in the following cases:
> After defining G20, G21, G22 or G23, the number of the subroutine it refers to is missing.
> The "N" character has not been programmed after function G25, G26, G27, G28 or G29.
> Too many nesting levels.
020 The axes of the circular interpolation are not programmed correctly.
021 There is no block at the address defined by the parameter assigned to F18, F19, F20, F21, F22.
022 An axis is repeated when programming G74.
023 K has not been programmed after G04.