Fagor 8025 GP, Operating Manual

Page: 350 / 423

230 8025/8030 CNC PROGRAMMING MANUAL
11. (M) MISCELLANEOUS FUNCTIONS
The miscellaneous functions are programmed by means of code M.
The miscellaneous functions are output in BCD code (M00/M99) or in binary code (M00/
M254) depending on the value assigned to the machine parameter P617(8).
Miscellaneous functions M41, M42, M43, M44 implicit with S cannot be programmed.
The CNC also has 15 decoded outputs for miscellaneous functions.
These outputs will be assigned to the required functions during the final adjustment of the
CNC to the machine.
The miscellaneous functions that are not assigned a decoded output are always performed
at the beginning of the block in which they are programmed.
In assigning a decoded output to any miscellaneous functions, a decision is also made as
to whether it is to be performed at the beginning or at the end of the block in which it is
programmed.
Up to a maximum of seven miscellaneous functions may be programmed in one block.
When more than one miscellaneous function is programmed in a block, the CNC performs
them consecutively in the order in which they are programmed.
Some of the miscellaneous functions have an internal meaning assigned to them in the
CNC.
11.1. M00. PROGRAM STOP
When the CNC reads code M00 in a block, it halts the program. The CYCLE START key
must be pressed for it to resume.
It is recommended that this function be set in the table of decoded M functions so that it
is performed at the end of the block in which it is programmed (see Installation and Start-
up Manual).