Operation, cont’d
CrossPoint 450 Plus and MAV Plus Switchers • Operation
3-44
Example 11: Viewing and adjusting an output volume level
The following steps show an example in which the audio output volume is viewed
and adjusted. The steps show the front panel indications that result from your
action.
Audio output volume is displayed differently on different models. See the table on
page 3-42.
For this reason, figure 3-68 and figure 3-71 show the indications displayed on a
switcher with 12 output buttons without duplicating all of the actions shown in
figure 3-67 and figure 3-70, which show switchers with 32 output buttons.
Figure 3-69 and figure 3-72 show the indications displayed on a switcher with 16
output buttons.
1
.
Press and release the Esc button (figure 3-65).
C O N T R O L
PRESET
ENTER
ESC
VIEW
Press the Esc button to clear all selections.
The button flashes once.
Figure 3-65 — Clear all selections
2
.
Press and hold the Audio button for approximately 2 seconds (figure 3-66).
AUDIO
AUDIO
Press and hold the Audio button until it blinks.
2 seconds
= Blinking button
Figure 3-66 — Select
Audio
mode
3
.
Press and release the output 17 button (figure 3-67).
I
N
P
U
T
S
12 13
14 15 16
28 29 30 31 32
1
17
O
U
T
P
U
T
S
2
17 18
1
7
1
19
3
2
Press and release
the Output 17 button.
The button lights
green.
The input buttons display the selected output's audio volume level.
Each lit input button beyond input 1 indicates 3 percent of the total input volume is applied to the
output. The flashing button indicates an additional 1.5 percent.
In this example, the
green
input buttons indicate 41.5 percent of the applied audio input. The
unlit
input buttons indicate an audio volume
attenuation
of 39 dB.
–39 dB attenuation,
41.5% volume
= Unlit button
= Blinking button
= Lit button
Figure 3-67 — Select output 17
im Vertrieb von
CAMBOARD Electronics
www.camboard.de
Tel. 07131 911201
Fax 07131 911203