Chapter 1: DS850 Overview
10
EVS5200_DOC_SOP_DS850
Raising and Lowering the DS850’s Cart Extension
To use the DS850 cart extension, lift up on the
extension until it is level and push up on the
brackets on both sides (as shown in the picture
on the right) until they lock into place.
To lower the extension, simultaneously press
the release button on the inside of the bracket
and press down on the hinge of the bracket.
Repeat this process with the other bracket and
carefully lower the extension. The extension
must not be allowed to drop as to prevent
damage to the extension and the cart.
Uninterruptible Power Supply (UPS)
You must use an Uninterruptible Power Supply (UPS) with the DS850. The UPS will
provide continuous power to the machine and to prevent the DS850 and the attached
printers from being damaged in case of a power surge. .
Installing New Firmware
A certified ES&S Technician will usually install new firmware on the DS850. If you have
been instructed to install the new firmware an ES&S Support Representative will assist
you in the process.
Note:
The DS850 was certified using an external UPS to comply with electrical test
requirements in the VVSG. The DS850 must be operated with an external UPS to be in a
certified configuration.
Reference:
See
Chapter 5: Pre-Election Day Tasks
for information on installing the UPS,
attaching the DS850 and printers to the UPS, turning on the UPS, and checking that the UPS
is communicating with the DS850.
Warning:
Contact an ES&S Technician for instructions to return your DS850 to an earlier
firmware version. Do not use an earlier firmware update Compact Flash card to revert a
DS850 firmware version back to an earlier version.
Note:
The Compact Flash card must be a minimum of 1 GB.
